RCC Structures Design Mcqs
RCC Structures Design Mcqs, this topic has 227 mcqs, It takes five to ten minutes to complete this free RCC Structures Design Mcqs test. You will see 4 or 5 option of each question. You must choose / think only one option and then press on answer key for check right answer. Practice "RCC Structures Design Mcqs" MCQs and share with your friends, brothers, sisters.
RCC Structures Design Mcqs (Total Quiz: 227)
MCQ: The load stress of a section can be reduced by______________?
- Decreasing the lever arm
- Increasing the total perimeter of bars
- Replacing larger bars by greater number of small bars
- Replacing smaller bars by greater number of greater bars
C
MCQ: The maximum ratio of span to depth of a slab simply supported and spanning in one direction, is______________?
- 35
- 25
- 30
- 20
C
MCQ: the column head support a flat slab, is generally kept The diameter of_____________?
- 0.25 times the span length
- 0.25 times the diameter of the column
- 4.0 cm larger than the diameter of the column
- 5.0 cm larger than the diameter of the column
A
MCQ: The floor slab of a building is supported on reinforced cement floor beams. The ratio of the end and intermediate spans is kept______________?
- 0.7
- 0.8
- 0.9
- 0.6
C
MCQ: In case the factor of safety against sliding is less than 1.5, a portion of slab is constructed downwards at the end of the heel slab, which is known as___________________?
- A key
- A cut-off wall
- A rib
- All the above
D
MCQ: Lapped splices in tensile reinforcement are generally not used for bars of size larger than______________?
- 18 mm diameter
- 24 mm diameter
- 30 mm diameter
- 36 mm diameter
D
MCQ: According to I.S. : 456, slabs which span in two directions with corners held down, are assumed to be divided in each direction into middle strips and edge strips such that the width of the middle strip, is______________?
- Half of the width of the slab
- Two -third of the width of the slab
- Three-fourth of the width of the slab
- Four-fifth of the width of the slab
C
MCQ: If the width of the foundation for two equal columns is restricted, the shape of the footing generally adopted, is__________________?
- Square
- Rectangular
- Trapezoidal
- Triangular
B
MCQ: Minimum spacing between horizontal parallel reinforcement of the same size should not be less than________________?
- One diameter
- 2.5 diameters
- 3 diameters
- 3.5 diameters
A
MCQ: For a ribbed slab______________?
- Clear spacing between ribs shall not be greater than 4.5 cm
- Width of the rib shall not be less than 7.5 cm
- Overall depth of the slab shall not exceed four times the breadth of the rib
- All the above
D