Design of Masonry Structures Mcqs
Design of Masonry Structures Mcqs, this topic has 41 mcqs, It takes five to ten minutes to complete this free Design of Masonry Structures Mcqs test. You will see 4 or 5 option of each question. You must choose / think only one option and then press on answer key for check right answer. Practice "Design of Masonry Structures Mcqs" MCQs and share with your friends, brothers, sisters.
Design of Masonry Structures Mcqs (Total Quiz: 41)
MCQ: The effective height of free standing nonload bearing wall and column respectively will be_________________?
- 1.OH and 1.OH
- 1.5Handl.5H
- 2.0Handl.5H
- 2.0H and 2.0H
D
MCQ: The thickness of each leaf of a cavity wall shall not be less than_________________?
- 5 cm
- 7.5 cm
- 10 cm
- 15 cm
B
MCQ: A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m2. The maximum height of wall from stability consideration is___________________?
- 0.64 m
- 0.96 m
- 1.28 m
- 1.5 m
A
MCQ: If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is_________________?
- 10%
- 25%
- 33 1/3%
- 50%
B
MCQ: The mode of failure of a very short masonry member having h/t ratio of less than 4 is by _______________?
- shear
- vertical tensile splitting
- buckling
- any of the above
A
MCQ: The timber floor not spanning on the masonry wall but properly anchored to the wall gives________________?
- lateral restraint but not rotational restraint
- rotational restraint but not lateral restraint
- both lateral and rotational restraints
- neither lateral nor rotational restraint
A
MCQ: Which of the following will give higher ratio of brickwork strength to mortar strength ?
- 1 : % : 3
- 1 : Vz: 4>/2
- 1:1:6
- 1:2:9
D
MCQ: Minimum compressive strength in N/mm2 for H1 type mortar used for masonry is_______________?
- 3
- 5
- 7.5
- 10
D
MCQ: For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing wall shall not be less than_________________?
- 50 cm
- 60 cm
- 75 cm
- 100 cm
B
MCQ: In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as________________?
- sum of thickness of both leaves
- two-third of the sum of thickness of both the leaves
- actual thickness of the stronger leaf
- larger of (B) and (C)
D